I have built a brass scorpion following gw instructions that I am happy with and I figured short of spending a lot of money on the greater brass scorpion I needed somthing unique .
Eneter the Soul scorpion .
required parts are basic and the conversion level is easy for even someone new to the hobby
you will need
a defiler kit
a brass scorpion kit
a gw wall set with an autocannon interceptor gun
a small peice of 1" pipe
Bitz order Khorne symbols ( or brass symbols from FW )
regular modeling tools and bandaids ( these bigger projects always require bandaids)
to start build up the center peice for both kits , for the brass scorpion the only thing you have to do is file off the bulge on the back of the kit to make it flush . for the defiler , fiel the back to flush and remove both of the arm claw ports , again filig down to smooth , attach the mid body chassy to the top of a peice of 1' pipe ( this can be wahtever height you want ) and place one of the detached claw bits at the top ( thus creating the hold for your soon to be ginormous tail cannon.
attach both the fornt and back peices ened to end and ensure it sets fully ( i would recommend green stuff or even reinforcing it with some extra bits you have about as this is the waekest link in the model )
let this dry fully because once the tail is attached it gets pretty heavy !
Step 3Now that the body is drying it is time to break out the interceptor gun and one arm , place most of it together and esnure to cut a straight line down to the thumb claw on the defiler arm , then attach the base of the interceptor gun so it is mostly flush ( dont worry about holes thats what filler is for ! )
easy peasy so far right ? now attach the gun as per intructions from the kit afind wall filler green stuff whatever is your fancy and fill in your hole behind the base of the interceptor gun ( I used quickpatch for drywall) finish off by attaching the arm plates to the defiler arm and use the demonic face plate for the battlecannon as a top plate for the interceptor guns